Ray Gateway, LAN/WAN & HA

Articles relating to Ray Gateway, LAN/WAN & HA

Ray Gateway, LAN/WAN & HA

Understand Network Interfaces

Network interface selection is very important while creating a wireless SSID profile. Let’s go through the common scenarios and interface selection.    TABLE OF...

Inheritance in Network Configuration

In a network cloud controller, inheritance refers to how configurations, policies, and permissions are propagated from a parent cluster to its child clusters. The...

Network – LAN/VLAN/WLAN and SNMP Configuration

LAN (Local Area Network) and VLAN (Virtual Local Area Network) are both types of networks. But, before configuration of LAN/VLAN, let’s quickly have a...

LAN Network Interface Setup Guide

A LAN (Local Area Network) Network Interface is a hardware or software component that enables a device to connect to a local network, allowing...

WAN Network Interface Setup Guide

A WAN (Wide Area Network) Network Interface is the connection point between a local network (such as a LAN) and a broader, geographically dispersed...

RAY WAN PROFILE CONFIGURATION

RAY WAN Profile Configuration: In this article, we will cover the creation of a WAN network interface configuration profile. Below are the summary steps:...

Configure WAN network interface for outbound traffic

By default, each LAN interface/network when created, a new dedicated zone is created for that particular network interface, and it gets restricted access. But...

Configuring WAN through Device Console Page

Configurating the WAN with a Static IP Address  To configure the WAN using a static IP address, navigate to the WAN Settings tab. Select the option Configure...

To configure Static IP on WAN interface, after connecting on cloud

An IP address is a unique address assigned to each device connected to a network that uses the Internet Protocol for communication. It serves...

How to Configure a Static IP on an Access Point

If your Access Point (AP) is not assigned an IP address via DHCP, you can access its local console page to set a Static...