Access Point Functioning as a IP Address Assignment
Steps 1: Create a LAN Profile. Steps 2: Create a WLAN Profile. – Go to the Network Interface section and...
Ray Gateway, LAN/WAN & HA
Last updated: Jul 06, 2026
How to configure Ray AP as Local DHCP server.
DHCP (Dynamic Host Configuration Protocol) is a protocol that provides quick, automatic, and central management for the distribution of IP addresses within a network. It’s also...
Last updated: Jul 06, 2026
How to Access Device Console Page
Accessing the Device Console Page To setup the WAN port of the device, you can access the Device Console Page to check its status...
Last updated: Jul 06, 2026
Configuring the Device Through Device Console Page
The Console Page allows you to configure the device while it is offline, tailoring the settings to meet your network requirements. Additionally, the status of...
Last updated: Jul 06, 2026
How to Configure a Static IP or PPPoE on an Gateway Device
If your Gateway Device is not assigned an IP address via DHCP, you can access its local console page to set a Static IP...
Last updated: Aug 17, 2026
Ray VRRP HA Debugging Guide
1. Check Interface IP Addresses First, verify that all required interfaces are present and in the UP state on both the Primary and Secondary...
Last updated: Jul 06, 2026
VRRP Concept Guide
Purpose and Scope This document explains the concept of Virtual Router Redundancy Protocol, commonly known as VRRP. It is intended for network engineers, deployment...
Last updated: Jul 06, 2026
LLDP for Improved Network Discovery
LLDP (Link Layer Discovery Protocol) is a network discovery protocol that helps devices on the same network (such as switches, routers, and computers) discover...
Last updated: Jul 07, 2026
Restrict Static IP
SCENARIO : Restrict Static IP CATEGORY : IP Management PURPOSE / USE CASE : Enforce DHCP use, prevent rogue configurations STEPS TO TEST : Enable restriction, connect client with static...
Last updated: Jul 07, 2026